When leaving the lift truck unattended the forks must be placed?

In addition, an unattended powered industrial truck is mentioned in rule 4081.2174, Parking (1) When leaving a powered industrial truck unattended, an operator shall fully lower the forks flat to the floor, neutralize the controls, set the brakes and shut the power off.

How should forks be positioned when truck is parked?

Forks should always be in the tilted downward position when parked. The best way to achieve this is for the operator to tilt them forward before lowering them to the ground.

When parking a lift truck the forks should be raised off the ground?

Keep the forks 6 to 10 inches above the ground to avoid potential hazards on the ground. Remember that forklifts are top-heavy. Carry the load low and tilted back.

THIS IS INTERESTING:  When was national flag first hoisted?

What are four precautions you should take prior to leaving a forklift unattended?

Parking Safety Rules

  • Always try to find a level surface to park on. …
  • Lower forks, or the forklift attachment, all the way to the ground. …
  • Put the gear into neutral.
  • Make sure the wheels are straight. …
  • Set the parking brake every time you park the forklift. …
  • Turn off the engine before dismounting the forklift.

What should you do when you park your lift truck?

How should you shutdown the forklift truck?

  1. Park in an approved location.
  2. Set the brakes.
  3. Lower the forks or load to the floor.
  4. Neutralize the controls.
  5. Turn off the motor switch or turn off controls and remove the key.
  6. Shut off the fuel supply (e.g., disconnect battery or go through propane shut-down procedures).

When parking or leaving your truck you should?

When parking or leaving your truck, you should: 1. Park or leave your truck in a safe area away from traffic. 2. Lower the forks until they are flat on the floor.

What must happen when a powered industrial truck is left unattended?

When a powered industrial truck is left unattended, load-engaging means shall be fully lowered, controls neutralized and brakes set. Unless the truck is in view and within 25 feet (7.62 m) of the operator, power shall be shut off. Wheels shall be blocked or curbed if the truck is on an incline.

What should you do before exiting an aisle?

13 What should you do before exiting an aisle or driving through a blind Intersection? c. Stop, sound the horn, look both ways, then move slowly.

THIS IS INTERESTING:  Quick Answer: How does Pascal's principle relate to hydraulic lifts?

What direction should the lift be driven down a ramp when carrying a load?

Drivers should always carry a load pointed up the incline, even when they are driving down an incline. That means that operators should drive in reverse with their heads turned down the ramp when they are descending with a load.

When riding on a ramp travels with the forks?

When going down a ramp, drive in reverse with the load and keep the forks pointed up the slope. When traveling without a load, the forks should always point down the slope. The forklift operator should also drive in reverse up the ramp or drive forward when going down the ramp.

When should you mount and dismount a lift truck?

When mounting or dismounting a forklift, always:

  1. Face the vehicle.
  2. Never jump off.
  3. Use a three-point stance (always have both hands and one foot or vice-versa in contact with the unit)
  4. Wear certified safety shoes (oil resistant and non-slippery)
  5. Wear suitable clothing (do not wear loose clothing or dangling jewelry)

What are two precautions you can take when operating a forklift on a wet or slippery surface?

Forklift Safety Precautions for Operating in the Rain

  • Can my forklift operate in the rain? …
  • Check Outdoor Conditions. …
  • Ensure Forklifts are Equipped with Rain Protection. …
  • Ensure all Operators and Staff Wear Correct Rain Protection.

How should you drive an unloaded lift truck on a ramp?

When traveling on a ramp with an unloaded forklift, always travel with the forks pointed downgrade, regardless of whether you are ascending or descending the ramp.

THIS IS INTERESTING:  How do you control a scissor lift?

Where can you not park a fork truck?

Do not park an industrial lift truck near doorways, switches and electricity boards, fire fighting equipment, blind corners, on inclines, on soft ground, middle of an aisle, fire exits or pedestrian walk ways.