Quick Answer: Why is my mower not cutting evenly?

Why is my mower cutting lower on one side?

If the deck on your lawn tractor is lower on one side than the other, the result is an uneven cut. Leveling your tractor’s deck periodically smooths out your lawn. It only takes a few minutes and just a couple of common tools to level your lawn tractor deck.

Why does my lawn mower not cut all the grass?

If your lawn mower is not cutting grass properly, check the deck, wheel adjustor, and blades. … The blade on your mower should be inspected at least once a year and sharpened or replaced as needed. Your lawn will actually tell you when your blade needs to be sharpened if you know what to look for.

Why does my mower leave lines?

Rows or streaks of uncut grass in your lawn may be the result of your lawnmower’s cutting blades being dull or otherwise damaged. Dull blades are the result of normal wear and tear from mowing. … Occasionally, one or both blades become warped, curled or nicked. In any one of those cases, it’s best to replace the blades.

THIS IS INTERESTING:  How many years do riding lawn mowers last?

How do I get my mower to cut higher?

In order to increase your lawn mower height, adjust the lever next to each wheel one notch towards the rear of the mower. Move the lever as many notches to the correct cutting height you desire. If you move the lever towards the front of the mower, you will lower the lawn mower height.

How do you cut uneven grass?

Try to dive straight up and down across the slope. This will reduce the risk of tripping over, and it will also help in mowing across the challenging slopes. To avoid scalping at uneven grounds, raise the deck of the mower and cut the grass taller just before you reach the top of the slope.

Should a lawn mower deck be level?

Level the mower deck to ensure grass cutting height is even across the width of the deck. This will help ensure a smooth and seamless side-by-side blend between each row of freshly cut grass.

Should mower deck wheels touch the ground?

Mower deck gauge wheels should be properly adjusted to prevent scalping grass on uneven terrain. The bottom of the wheels should sit approximately 1/8-1/2 of an inch from the ground, depending on your cutting height.

How do you mow without leaving lines?

If you notice lines in your lawn after you mow it, you should check to ensure that your blades are sufficiently sharp for cutting. To make sure that your blades are suitable, you should sharpen them between once and twice per season. Oh, and by the way, blunt blades can cause other problems, too.

THIS IS INTERESTING:  You asked: How do you start a Briggs and Stratton self propelled lawn mower?

Should you mow clockwise or counterclockwise?

If a trail of clippings is forming on the right hand side of the mowing swath, use a clockwise pattern. If a trail of clippings is forming on the left hand side of the mowing swath, use a counterclockwise mowing pattern.

Should you edge before or after mowing?

Some people find that by trimming the edges first you are able to mow over the cut grass from the edges, which will leave the lawn clean of debris when finished. But if you don’t mind blowing these trimmings away afterwards, then it doesn’t really matter.