How do you troubleshoot a snowblower?

What would cause a snowblower not to start?

A common issue is a clogged carburetor from stale gas. Using a fuel stabilizer keeps fuel fresh and the carburetor from gumming and varnishing. Third step, check the ignition system with a spark tester. Step four, replace the spark plug and reconnect the spark plug wire.

Why would a snow blower stop working?

A clogged carburetor is usually the result of leaving fuel in your snow blower for an extended period of time. Old fuel resting in your snow blower can also result in fuel evaporation, which may leave behind a thick, sticky substance. That sticky fuel can clog the carburetor and prevent the engine from starting.

How do you start a snowblower that has been sitting?

How To Start A Snowblower That Has Been Sitting?

  1. Check If All Switches Are In The Right Position.
  2. Change The Gas And Add Stabilizer To It.
  3. Prime The Engine.
  4. Clean The Carburetor.
  5. Check The Fuel Line And Fuel Filter.
  6. Replace The Spark Plug.

What happens if you prime a snowblower too much?

Priming the engine moves fuel through the fuel lines and into the carburetor. Our Toro snowblower recommends pressing the primer button twice. We’ve found it actually requires more like 8-10 pumps to get going. Be careful not to over-prime, however, since it can flood the engine.

THIS IS INTERESTING:  Best answer: How do you choke a snowblower?

How do you clean a carburetor on a snowblower without taking it apart?

Spray carburetor cleaner on the inside of the bowl and wipe the liquid, dirt, and concentrated fuel off of it. Now take the main jet, spray the cleaner through it and wipe off the dirt. Then take a copper wire, scrub it through the tiny holes in the jet to complete the cleaning process.

Why is my snowblower losing power?

The spark plug ignites the air/fuel mixture in the engine of your snow blower. If your spark plug is worn, dirty, oily, or incorrectly gapped, the spark will be weak. This could lead to misfire or detonate, causing a loss of power.

Why is my snowblower auger not turning?

A broken shear pin is the most common reason the snowblower auger won’t turn properly so replace any broken shear pins. Worn or loose belts also prevent the snowblower auger from spinning. Check and adjust the belts and replace any broken or worn belts when you see the snowblower auger not turning.

How do I know if my shear pin is broken?

When it’s safe, visually inspect the augers. If you don’t see the shear pin head or nut and you can manually spin the auger along the auger shaft, you broke a shear pin.

Where do you spray a quick start snowblower?

Spray Starter Fluid Into the Air Intake

Now that you’ve found the air intake valve and opened the choke, spray your starter fluid directly into the air intake. Spray in short bursts about 1 second long. Spray 2–3 bursts into the air intake. Any more than this won’t help your blower start but it can damage your engine.

THIS IS INTERESTING:  Is Cub Cadet a good snow blower?