Quick Answer: How do I start my first snowblower?

How do you prepare a new snow blower?

INSTRUCTIONS:

  1. Prepare your snow blower for maintenance. Place your snow blower on a flat surface. …
  2. Change the engine oil in your snow thrower. …
  3. Install a new spark plug if necessary. …
  4. Inspect belts for wear. …
  5. Drain the gas tank and replace with fresh fuel. …
  6. Lubricate the drive and chassis.

How do you start a snowblower after sitting for years?

How To Start A Snowblower That Has Been Sitting?

  1. Check If All Switches Are In The Right Position.
  2. Change The Gas And Add Stabilizer To It.
  3. Prime The Engine.
  4. Clean The Carburetor.
  5. Check The Fuel Line And Fuel Filter.
  6. Replace The Spark Plug.

How do you start a snowblower in cold weather?

Electric start snow blowers plug into an extension cord. Once plugged in, push the small button near the plug until it starts, then unplug the cord and you’re good to go. Some models have an automotive-style ignition, which starts like a car or truck. Just turn the key and clear some snow.

THIS IS INTERESTING:  Your question: How far can a semi truck go on a full tank?

What happens if you prime a snowblower too much?

Priming the engine moves fuel through the fuel lines and into the carburetor. Our Toro snowblower recommends pressing the primer button twice. We’ve found it actually requires more like 8-10 pumps to get going. Be careful not to over-prime, however, since it can flood the engine.

Why does my snowblower not start?

The snowblower engine needs gas, compression and spark to start, so if your snowblower isn’t starting, focus on those. First, make sure the gas in the tank is fresh; older gas can form gummy deposits that interfere with starting. Gummy deposits clog the carburetor so clean or replace the carburetor if it’s clogged.

What do I do if I left the gas in my snowblower?

If you left fuel in the tank over the summer, it’s best to drain it by accessing the fuel line or using a siphon system. If that leftover gas is less than a third of the tank, top it off with some fresh fuel, and be sure to include a fuel stabilizer to help condition the mix.

Do you start a snowblower with the choke on or off?

Always use the choke to start a cold engine, turning to “Full Choke.” Check your Owner’s Manual for proper choke positioning. If the temperature is above 32 degrees, priming the carburetor may flood the engine easily so try only choking the engine.

How do I know if my choke is open or closed?

Turn on the ignition of your car. Once the engine is warm, you can remove the air filter and check whether the choke is open or closed. At this point, the choke should be open to allow the engine to breathe fully.

THIS IS INTERESTING:  What is the best electric cordless snow blower?

How do you start a choke on a snowblower?

Refer to your owner’s manual for detailed starting instructions specific to your model.

  1. 1.) Set the Choke to FULL. …
  2. 2.) Move the Throttle to the FAST Position (rabbit symbol) …
  3. 3.) Open the Fuel Shutoff Valve. …
  4. 4.) Flip the Ignition Switch to RUN. …
  5. 5.) Insert the Safety Ignition Key. …
  6. 6.) …
  7. 7.) …
  8. Plug in the Power Cord.

Why is my Toro snow blower not starting?

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the snowblower for a long period of time. … This sticky fuel can clog up the carburetor and prevent the engine from starting. If the carburetor is clogged, try cleaning it with carburetor cleaner.